Trending-accessibility Adjustable fusion shower pan on wood joists Bedienungsanleitung PDF herunterladen (Seite 7)

Installation Guide

www.trendingaccessibility.com [email protected]

for adjustable fusion shower pan on wood joists

Step 13 > > > > > > > >

Carefully set the Fusion Pan into place. Using

the 2 ½” screws provided, attach the pan. Do not

aggressively screw and over tighten, as you may

force the Fusion Pan out of level.

Pre-drill the holes for the rotating plate. Now attach

the rotating plate using the ¾” screws provided. Be

sure to match up your tick marks done in step 8.

Refer to the Cutting and Drilling guidline on page 12

Step 14 > > > > > > > >

On top of existing subfloor install cement

backerboard in preparation for tiling. Make sure

that the top of the backerboard is roughly 1/8”

higher than the Fusion Pan.

Step 16 > > > > > > > >

You now want to attach the Drain adapter flange

to the Fusion Pan.

First, set the adapter in place, mark the 4 holes,

and pre-drill them with a 1/8” bit.

Then apply a bead of caulk (

Recommended: DAP

Dynaflex 230)

to the underside of the drain adapter

flange. Lightly push the flange into place, and

screw it down using the four ¾” screws provided.

Remove any excess caulk that squeezes out.

membrane clamp

height adjustment ring

Remove the tile height adjustment ring and membrane clamp and

place to one side; these will be required later in the installation.

Gasket Clamp

Adapter Drain Flange

Step 15 > > > > > > > >

Check that the Fusion Pan is level on all four sides.

Fill in any gaps around the perimeter of the pan over

1/8” with latex or acrylic caulk.

Recommended: DAP Dynaflex 230

Do not use 100% silicone.

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

Trending-accessibility Adjustable fusion shower pan on wood joists Bedienungsanleitung Seite 7